Get an extra two 6-tube Mini Mr.Bulletfeeder magazine assemblies with this great Combo offer
Your Combo includes:
3 x 6-Tube Bullet Magazine Assembly
1 x Dropper Die Assembly
3 x Spare Steel Ball-Bearings for Dropper
1 x User Instruction Sheet
The Mini Mr.Bulletfeeder by DAA uses a 6-tube magazine system which
holds roughly 100 bullets. It feeds into the same brilliantly reliable
dropper die assembly as used on the Mr.Bulletfeeder.
Using a Bulletfeeder while reloading is a real pleasure. It makes the
reloading process faster and much easier. If you have never used one,
you are missing out on one of the greatest reloading assists out there!
A Bulletfeeder also improves safety, by preventing the need to insert
your fingers under the tool head to place your bullets on the brass.
Everyone should use one!
The problem of course, is cost. Shooting is expensive, and reloading
ammo, while usually cheaper than shooting factory, is not as cheap as it
once was…
You need to buy a press, other reloading accessories, not to mention
ammo components. For many, by the time all that is purchased, they have
stretched their budget about as far as it will go. And the Bulletfeeder
gets passed on, for lack of funds.
This was our motivation when setting out to develop a less expensive
version of the Mr.Bulletfeeder, and it lead to the new Mini
Mr.Bulletfeeder.
Each magazine of bullet tubes needs to be filled by hand before
reloading, much in the same way you would fill your primer tubes before
starting your reloading session. With a little practice, it will take
you about 2 minutes to fill the tube assembly. And this can be done in
advance while watching TV in the comfort of your living room.
Additional tube assemblies can be purchases separately (or as a bundle),
thus allowing you to pre-load 300, 400 or more bullets before starting
your reloading session.
While reloading, you will see the bullets drop down in the transparent
tube, as they feed into the dropper-die assembly. Once a tube is empty,
you simply rotate and click the next tube into place and keep reloading.
Transition to the next tube takes just a second or two. Once the entire
6-tube magazine is empty, either reload it by hand, or drop your 2nd
assembly into place to continue without delay.
The Mini Mr.Bulletfeeder can be used on any progressive reloading
machine which uses the same size dies as Dillon, however please note
that the powder funnel we supply with the Mini Mr.Bulletfeeder is
designed to be used only in the Dillon powder drop! If you wish to use
the Mini Mr.Bulletfeeder with another press, you may need to get another
powder funnel to expand the brass.
Be aware that the bullet feeder does require a station in your tool head, directly after the powder dropper.
We have found it is difficult to use the Mini Mr.Bulletfeeder on a 1050
when a powder check is being used in the following station. This has to
do with the angle in which the powder dropper sits, forcing the bullet
dropper to rotate further away, over the next station. This is an issue
only on a 1050.
the expanding powder funnel supplied is for the Dillon reloading machines only. Not compatible with other brands.
To use with the LnL press, you will need to purchase their expanding powder funnel separately.